Cisco Aironet 1100 Series - Creating an IP Filter

15-6
Cisco Aironet 1100 Series Access Point Installation and Configuration Guide
OL-2851-01
Chapter 15 Configuring Filters
Configuring Filters Using the Web-Browser Interface
Figure 15-3 IP Filters Page
Follow this link path to reach the IP Filters page:
1. Click Services in the page navigation bar.
2. In the Services page list, click Filters.
3. On the Apply Filters page, click the IP Filters tab at the top of the page.
Creating an IP Filter
Follow these steps to create an IP filter:
Step 1 Follow the link path to the IP Filters page.
Step 2 If you are creating a new filter, make sure <NEW> (the default) is selected in the Create/Edit Filter Index
menu. To edit an existing filter, select the filter name from the Create/Edit Filter Index menu.
Step 3 Enter a descriptive name for the new filter in the Filter Name field.