EasyManua.ls Logo

Cisco Aironet 1100 Series

Cisco Aironet 1100 Series
320 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12-9
Cisco Aironet 1100 Series Access Point Installation and Configuration Guide
OL-2851-01
Chapter 12 Configuring VLANs
VLAN Configuration Example
Table 12-3 shows the results of the configuration commands in Table 12-2. Use the show running
command to display the running configuration on the access point.
Notice that when you configure a bridge group on the radio interface, these commands are set
automatically:
bridge-group 2 subscriber-loop-control
bridge-group 2 block-unknown-source
no bridge-group 2 source-learning
no bridge-group 2 unicast-flooding
bridge-group 2 spanning-disabled
When you configure a bridge group on the FastEthernet interface, these commands are set automatically:
no bridge-group 2 source-learning
bridge-group 2 spanning-disabled
Table 12-3 Results of Example Configuration Commands
VLAN 1 Interfaces VLAN 2 Interfaces VLAN 3 Interfaces
interface Dot11Radio0.1
encapsulation dot1Q 1 native
no ip route-cache
no cdp enable
bridge-group 1
bridge-group 1
subscriber-loop-control
bridge-group 1
block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
bridge-group 1 spanning-disabled
interface Dot11Radio0.2
encapsulation dot1Q 2
no ip route-cache
no cdp enable
bridge-group 2
bridge-group 2
subscriber-loop-control
bridge-group 2
block-unknown-source
no bridge-group 2 source-learning
no bridge-group 2 unicast-flooding
bridge-group 2 spanning-disabled
interface Dot11Radio0.3
encapsulation dot1Q 3
no ip route-cache
bridge-group 3
bridge-group 3
subscriber-loop-control
bridge-group 3 block-unknown-source
no bridge-group 3 source-learning
no bridge-group 3 unicast-flooding
bridge-group 3 spanning-disabled
interface FastEthernet0.1
encapsulation dot1Q 1 native
no ip route-cache
bridge-group 1
no bridge-group 1 source-learning
bridge-group 1 spanning-disabled
interface FastEthernet0.2
encapsulation dot1Q 2
no ip route-cache
bridge-group 2
no bridge-group 2 source-learning
bridge-group 2 spanning-disabled
interface FastEthernet0.3
encapsulation dot1Q 3
no ip route-cache
bridge-group 3
no bridge-group 3 source-learning
bridge-group 3 spanning-disabled

Table of Contents

Related product manuals