Cisco ASR 900 Series - MPLS LSP Ping and Traceroute Returns a Q

Table 6: Bandwidth Used by Different Rates
Bandwidth (kbit/s)Rate
150,336STM-1
601,344STM-4
2,405,376STM-16
9,621,504STM-64
Restrictions for Scale PW Circuits
•
Only 1000 CEM PW Circuits per OCN Interface modules are supported.
Configuring Mediatype Controller
Each SFP port (0-7) can be configured as STM-1, STM-4, STM-16, or GigabitEthernet. SFP+ port (8) can
be configured as STM-64 or 10 GigabitEthernet.
You must select the MediaType controller to configure and enter the controller configuration mode.
You must configure the controller as a SDH port.
To configure MediaType Controller:
enable
configure terminal
controller MediaType 0/5/0
mode sdh
end
Configuring Rate on SDH Ports
To configure rate on SDH ports:
enable
configure terminal
controller MediaType 0/5/0
mode sdh
controller sdh 0/5/0
rate [stm1 | stm4 | stm16 | stm64]
end
STM-64 can only be configured only on the last port or port 8.Note
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x
(Cisco ASR 900 Series)
88
Configuring SDH on 1-Port OC-192/STM-64 or 8-Port OC-3/12/48/STM-1/-4/-16 Module
Configuring Mediatype Controller