Cisco ASR 900 Series Configuration Guide

•
When mode changing command is applied by copying from a file (from TFTP server), the IM reloads
and as a result subsequent configurations fail for that IM. hence, you should change the mode of the IM
to 5G mode or vice versa before copying the configurations from the TFTP file.
Configuring 5G Mode from 10G Mode
To configure 5G mode from 10G mode:
enable
configure terminal
platform hw-module configuration
hw-module <slot> / <subslot> <PID> mode 5G_CEM
end
Configuring 10G Mode from 5G Mode
To configure 10G mode from 5G mode:
enable
configure terminal
platform hw-module configuration
hw-module <slot> / <subslot> <PID>
end
Verification of 5G Traffic Configuration
Use the show running configuration command to verify 5G traffic configuration:
Router#show running-config | include mode
hw-module 0/bay PID mode 5G_CEM
Router#
Associated Commands
The following table shows the associated commands for 5G traffic configuration:
LinksCommands
http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/
mcl/allreleasemcl/all-book/all-06.html
hw-module mode
http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/
mcl/allreleasemcl/all-book/all-10.html
platform hw-module configuration
http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/
mcl/allreleasemcl/all-book/all-14.html
show running configuration | include mode
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x (Cisco
ASR 900 Series)
153
Configuring 5G Mode on 1-Port OC-192/STM-64 or 8-Port OC-3/12/48/STM-1/-4/-16 Interface Module
Configuring 5G Mode from 10G Mode

Cisco ASR 900 Series Specifications

General

Brand	Cisco
Model	ASR 900 Series
Category	Network Router
Language	English