EasyManua.ls Logo

Cisco ASR 900 Series - Configuring AIS Shut

Cisco ASR 900 Series
172 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Configuring AIS Shut
To configure AIS-Shut:
enable
configure terminal
controller sdh 0/5/0
ais-shut
end
The no ais-shut command does not send AIS.Note
Shutdown
Disables the interface.
Configuring Shut
To configure Shut:
enable
configure terminal
controller sdh 0/5/0
shutdown
end
Use the no shutdown command to disable the interface.Note
Alarm Reporting
Enables reporting for all or selected alarms.
• b1-tca — Enables BER threshold crossing alarm for B1.
• b2-tca — Enables BER threshold crossing alarm for B2.
• b3-tca — Enables BER threshold crossing alarm for B3.
• lais —Enables line alarm indication signal.
• lom — Enables loss of multiframe signal.
• lrdi — Enables line remote defect indication signal.
• pais — Enables path alarm indication signal.
• plop — Enables loss of pointer failure signal for a path.
• pplm — Enables path payload mismatch indication.
• prdi — Enables path remote defect indication signal.
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x (Cisco
ASR 900 Series)
91
Configuring SDH on 1-Port OC-192/STM-64 or 8-Port OC-3/12/48/STM-1/-4/-16 Module
Shutdown

Table of Contents

Other manuals for Cisco ASR 900 Series

Related product manuals