Cisco ASR 900 Series - Example: Applying the MPLS EXP Label Switched Packets Policy Map to a Main Interface; Additional References for CEM over MPLS Qos

Example: Applying the MPLS EXP Label Switched Packets Policy Map to a
Main Interface
Example: Applying the MPLS EXP Label Switched Packets Policy Map to a Main Interface
The following example shows how to apply the policy map to a main interface:
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)# interface GigabitEthernet 0/0/0
Router(config-if)# service-policy input mark-up-exp-2
Router(config-if)# exit
Additional References for CEM over MPLS QoS
Related Documents
Document TitleRelated Topic
Cisco IOS Master Commands List, All Releases
Cisco IOS commands
Standards
TitleStandards
There are no standards for this feature.
—
MIBs
MIBs LinkMIB
To locate and download MIBs for selected platforms,
Cisco IOS releases, and feature sets, use Cisco MIB
Locator found at the following URL:
http://www.cisco.com/go/mibs
—
RFCs
TitleRFCs
There are no RFCs for this feature.
—
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x
(Cisco ASR 900 Series)
16
CEM over MPLS QoS
Example: Applying the MPLS EXP Label Switched Packets Policy Map to a Main Interface