Cisco ASR 900 Series - MPLS Multilink PPP Support; Prerequisites for MPLS Multilink PPP Support; Restrictions for MPLS Multilink PPP Support

mode vt-15
end
There is no default mode. The following modes are supported:Note
•
mode vt-15
•
mode ct3
•
mode cte-e1
•
mode t3
•
mode unframed
•
mode vt-2
To restore the system to its default condition, use the no form of the command.Note
Configuring DS1/T1 CT3 mode of STS-1
To configure DS1/T1 CT3 mode of STS-1, you can configure the T1 link using the following steps:
enable
configure terminal
controller sonet 0/5/0
sts-1 1
mode ct3
t1 1 clock source internal
t1 1 framing unframed
end
To restore the system to its default condition, use the no form of the command.Note
Configuring STS-Nc - Contiguous Concatenation
To configure STS-Nc - contiguous concatenation, use the following commands:
enable
configure terminal
controller sonet 0/5/0
sts-1 1-3 mode sts-3c
end
To restore the system to its default condition, use the no form of the command.Note
To configure STS-3c or STS-12c, use the numbers as multiples for 3 or 12, respectively.Note
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x (Cisco
ASR 900 Series)
39
Configuring SONET
Managing and Monitoring SONET Line