Cisco ASR 900 Series - Configuring Alarm Reporting

• puneq — Enables path unequipped (path label equivalent to zero) signal.
• sd-ber — Enables LBIP BER in excess of SD threshold.
• sf-ber — Enables LBIP BER in excess of SF threshold.
• slof — Enables section loss of frame signal.
• slos — Enables section loss of signal.
Configuring Alarm Reporting
To configure alarm reporting:
enable
configure terminal
controller sdh 0/5/0
alarm-report [b1-tca | b2-tca | b3-tca | lais | lom | lrdi | pais | plop | pplm | prdi |
puneq | sd-ber | sf-ber | lof | los]
end
To restore the system to its default condition, use the no form of the alarm report command.Note
Clock Source
Specifies the clock source, where
• line —The link uses the recovered clock from the line.
• internal — The link uses the internal clock source. This is the default setting.
Configuring Clock
To configure clock, use the following commands:
enable
configure terminal
controller sdh 0/5/0
clock source [line | internal]
end
The default mode is internal.Note
To restore the system to its default condition, use the no form of the command.Note
Configuring Network-Clock SDH
To configure network-clock SDH, use the following commands:
enable
configure terminal
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x
(Cisco ASR 900 Series)
92
Configuring SDH on 1-Port OC-192/STM-64 or 8-Port OC-3/12/48/STM-1/-4/-16 Module
Clock Source