Cisco ASR 900 Series - SDH Multiplexing

Configuration DetailsSDH Circuits
•
Configuring Mediatype Controller
•
Configuring Rate on SDH Ports
•
Configuring AU-3 or AU-4 Mapping
•
Configuring Mode VC-1x
•
Configuring AU-3—TUG-2—VC-11—T1
Configuring (AU-3) VC-3—TUG-2—VC-12—T1
circuit
•
Configuring Mediatype Controller
•
Configuring Rate on SDH Ports
•
Configuring AU-3 or AU-4 Mapping
•
Configuring Mode VC-1x
•
Configuring AU-3—TUG-2—VC-12—E1
Configuring (AU-3) VC-3—TUG-2—VC-12 circuit
•
Configuring Mediatype Controller
•
Configuring Rate on SDH Ports
•
Configuring AU-3 or AU-4 Mapping
•
Configuring Mode VC-1x
•
Configuring AU-3—TUG-2—VC-11—T1
Configuring (AU-3) VC-3—TUG-2—VC11 circuit
•
Configuring Mediatype Controller
•
Configuring Rate on SDH Ports
•
Configuring AU-3 or AU-4 Mapping
•
Configuring Mode VC-1x
•
Configuring AU-3—TUG-2—VC-12—E1
Configuring (AU-3) VC-3—TUG-2—VC11—E1
circuit
SDH Multiplexing
The terms and definitions of SDH multiplexing principles are:
• Mapping – A process used when tributaries are adapted into VCs by adding justification bits and Path
Overhead (POH) information.
• Aligning – This process takes place when a pointer is included in a Tributary Unit (TU) or an
Administrative Unit (AU), to allow the first byte of the VC to be located.
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x (Cisco
ASR 900 Series)
75
Configuring SDH on 1-Port OC-192/STM-64 or 8-Port OC-3/12/48/STM-1/-4/-16 Module
SDH Multiplexing