Cisco ASR 900 Series - CHAPTER 3 Configuring SONET

CHAPTER 3
Configuring SONET
This module describes how to configure Synchronous Optical NETwork (SONET). SONET defines optical
signals and a synchronous frame structure for multiplexed digital traffic. SONET equipment is generally
used in North America.
The transport network using SONET provides much more powerful networking capabilities than existing
asynchronous systems.
•
Overview of SONET, page 20
•
Restrictions for SONET, page 20
•
SONET Switching , page 21
•
SONET Hierarchy, page 22
•
STS-1 and STS-3 Frames, page 23
•
SONET Line and Section Configuration Parameters, page 24
•
BERT, page 25
•
Concatenated SONET Frames, page 26
•
SONET Path Level Configuration Parameters, page 26
•
Channelized SONET Frames, page 27
•
SONET T1 Configuration Parameters, page 27
•
SONET T3 Configuration Parameters, page 27
•
SONET VT Configuration Parameters, page 28
•
SONET Protection Switching , page 28
•
Alarms at SONET Layers, page 33
•
How to Configure SONET, page 35
•
ONS Pluggables, page 51
•
Configuring BERT in Sonet for CESoPSN, page 53
•
Clock Recovery System in CESoPSN, page 55
•
Configuring Clocking for ACR and DCR on APS for CESoPSN, page 60
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x (Cisco
ASR 900 Series)
19