Cisco ASR 900 Series Configuration Guide

Verifying Clocking DCR for MSP AU3-T1 in CESoPSN
Use the show recovered-clock command to verify the DCR for AU3-T1 in CESoPSN:
Router# show recovered-clock
Recovered clock status for MSP-DCR 200
----------------------------------------
Clock Type Mode CEM Status Circuit-No Working Protect
Priority
5 OCx-T1 DIFFERENTIAL 44 ACQUIRING 200/4/1/1(acr/path/vtg/t1) ACQUIRING ACQUIRING
1
Configuring Clocking ACR for MSP AU4-E1 in CESoPSN
To configure clock source on MSP for the working controller, use the following commands:
enable
configure terminal
controller sdh 0/3/6
au-4 1
tug-3 1
tug-2 1 payload vc12
e1 1 clock source recovered 5
end
To configure the recovered clock, use the following commands:
enable
configure terminal
recovered-clock acr 200
clock recovered 5 adaptive cem 1 priority 1
end
To configure clock source on MSP for the protect controller, use the following commands:
enable
configure terminal
controller sdh 0/4/6
au-4 1
tug-3 1
tug-2 1 payload vc12
e1 1 clock source recovered 5
end
To configure the recovered clock, use the following commands:
enable
configure terminal
recovered-clock acr 200
clock recovered 5 adaptive cem 2 priority 2
end
Verifying Clocking ACR for MSP AU4-E1 in CESoPSN
Use the show recovered-clock command to verify the ACR for AU4-E1 in CESoPSN:
Router# show recovered-clock
Recovered clock status for MSP-ACR 200
----------------------------------------
Clock Type Mode CEM Status Circuit-No Working Protect
Priority
4 OCx-T1 ADAPTIVE 38 ACQUIRING 200/3/1/1(acr/path/vtg/t1) ACQUIRING ACQUIRING
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x (Cisco
ASR 900 Series)
123
Configuring MSP on 1-Port OC192/STM-64 or 8-Port OC3/12/48/STM-1/-4/-16 Module
Verifying Clocking DCR for MSP AU3-T1 in CESoPSN

Cisco ASR 900 Series Specifications

General

Brand	Cisco
Model	ASR 900 Series
Category	Network Router
Language	English