CHAPTER 4
Configuring SDH on 1-Port OC-192/STM-64 or
8-Port OC-3/12/48/STM-1/-4/-16 Module
SDH is a standard that defines optical signals as well as a synchronous frame structure for multiplexed digital
traffic. It is is used in Europe by the International Telecommunication Union Telecommunication
Standardization Sector (ITU-T). The SDH equipment is used everywhere except North America.
SONET equipment is generally used in North America. Previously, 4-Port OC3 STM1 or 1-Port OC12 STM4
Module did not support all possible combinations of the SDH hierarchy.
SDH is supported on 1-Port OC-192/STM-64 or 8-Port OC-3/12/48/STM-1/-4/-16 Module along with
SONET. The IM supports the entire SDH hierarchy (except VC-2/C-2).
•
Overview of SDH, page 70
•
Services Provided by SDH Configuration, page 73
•
SDH Multiplexing, page 75
•
Restrictions for SDH in SAToP, page 86
•
Restrictions for SDH in CESoPSN, page 87
•
Configuring Mediatype Controller, page 88
•
Configuring Rate on SDH Ports, page 88
•
SDH Line and Section Configuration Parameters, page 89
•
Configuring SDH Path Parameters, page 93
•
Configuring BERT in SDH for SAToP, page 96
•
Configuring BERT in SDH for CESoPSN, page 99
•
SDH T1/E1 Configuration Parameters for SAToP, page 101
•
SDH T3/E3 Configuration Parameters for SAToP, page 102
•
SDH VC Configuration Parameters for SAToP, page 103
•
Configuring CEM Group for CESoPSN, page 105
•
Configuring ACR and DCR for SAToP, page 107
•
Configuring ACR and DCR for CESoPSN, page 109
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x (Cisco
ASR 900 Series)
69
To Next Page
Loading...
