Configuring Call Home
How to Configure Call Home
7
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
3. mail-server {ipv4-address | name} priority number
DETAILED STEPS
Example:
The following example shows the configuration of a primary mail server (named “smtp.example.com”)
and secondary mail server at IP address 192.168.0.1:
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)# call-home
Router(cfg-call-home)# mail-server
smtp.example.com priority 1
Router(cfg-call-home)# mail-server
192.168.0.1 priority 2
Router(cfg-call-home)# exit
Router(config)#
Associating the Management Interface VRF With Call Home
The Call Home feature requires the management interface VRF (Mgmt-intf) to provide e-mail messaging
support. If you have not configured the management interface VRF, see the “Configuring the
Management Interface VRF” section on page 4.
To associate the management interface VRF wit
h Call Home, complete the following steps:
SUMMARY STEPS
1. configure terminal
2. call-home
3. vrf Mgmt-intf
Command or Action Purpose
Step 1
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 2
call-home
Example:
Router(config)# call-home
Enters call home configuration mode.
Step 3
mail-server {ipv4-address | name} priority
number
Example:
Router(cfg-call-home)# mail-server
stmp.example.com priority 1
Specifies an e-mail server and its relative priority among
configured e-mail servers, where:
• ipv4-address—Specifies the IPv4 address of the mail
server.
• name—Specifies the mail server’s fully qualified
domain name (FQDN) of 64 characters or less.
• number—Assigns a number between 1 (highest
priority) and 100 (lowest priority).
To Next Page
Loading...
