Cisco ASR1002 - ASR 1002 Router - Configuring Persistent SSH; Examples

Console Port, Telnet, and SSH Handling
Configuring Persistent SSH
8
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
Configuring Persistent SSH
This task describes how to configure persistent SSH on the Cisco ASR 1000 Series Routers.
SUMMARY STEPS
1. (Required) enable
2. (Required) configure terminal
3. (Required) transport-map type persistent ssh transport-map-name
4. (Required) connection wait [allow {interruptible} | none {disconnect}]
5. (Required) rsa keypair-name rsa-keypair-name
6. (Optional) authentication-retries number-of-retries
7. (Optional) banner [diagnostic | wait] banner-message
8. (Optional) time-out timeout-interval-in-seconds
9. (Required) transport interface GigabitEthernet 0
10. (Required) exit
11. (Required) transport type persistent ssh input transport-map-name
DETAILED STEPS
Command or Action Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
transport-map type persistent ssh
transport-map-name
Example:
Router(config)# transport-map type persistent
ssh sshhandler
Creates and names a transport map for handling persistent
SSH connections, and enters transport map configuration
mode.