Configuring Call Home
How to Configure Call Home
23
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)# call-home
Router(cfg-call-home)# contact-ema
il-addr username@example.com
Router(cfg-call-home)# phone-numbe
r +1-222-333-4444
Router(cfg-call-home)# street-addr
ess “1234 Any Street, Any city, Any state, 12345”
Router(cfg-call-home)# customer-id
Customer1234
Router(cfg-call-home)# site-id Sit
e1ManhattanNY
Router(cfg-call-home)# contract-id
Company1234
Router(cfg-call-home)# exit
Configuring the Number of Call Home Messages Sent Per Minute
The Call Home feature defaults to a maximum of 20 messages per minute. If you want to change that
value, complete the following steps:
SUMMARY STEPS
1. configure terminal
2. call-home
3. rate-limit number
DETAILED STEPS
Enabling and Disabling Call Home
To enable or disable the Call Home feature, complete the following steps:
SUMMARY STEPS
1. configure terminal
2. service call-home
3. no service call-home
Command or Action Purpose
Step 1
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 2
call-home
Example:
Router(config)# call-home
Enters call home configuration mode.
Step 3
rate-limit number
Example:
Router(cfg-call-home)# rate-limit 40
Specifies a limit on the number of messages sent per
minute. Range 1 to 60. The default is 20.
To Next Page
Loading...
Need help?
General
