Using the Management Ethernet Interface
Common Ethernet Management Tasks
6
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
FTP Example
Router(config)# ip ftp source-interface gigabitethernet 0
NTP Server
To allow the software clock to be synchronized by a Network Time Protocol (NTP) time server over the
Management Ethernet interface, enter the ntp server vrf Mgmt-intf command and specify the IP
address of the device providing the update.
The following CLI provides an example of this procedure.
Router(config)# ntp server vrf Mgmt-intf 172.17.1.1
SYSLOG Server
To specify the Management Ethernet interface as the source IP or IPv6 address for logging purposes,
enter the logging host <ip-address> vrf Mgmt-intf command.
The following CLI provides an example of this procedure.
Router(config)# logging host <ip-address> vrf Mgmt-intf
SNMP-Related Services
To specify the Management Ethernet interface as the source of all SNMP trap messages, enter the
snmp-server source-interface traps gigabitEthernet 0 command.
The following CLI provides an example of this procedure:
Router(config)# snmp-server source-interface traps gigabitEthernet 0
Domain Name Assignment
The IP domain name assignment for the Management Ethernet interface is done through the VRF.
To define the default domain name as the Management Ethernet VR
F interface, enter the ip
domain-name vrf Mgmt-intf domain command.
Router(config)# ip domain-name vrf Mgmt-intf cisco.com
DNS service
To specify the Management Ethernet interface VRF as a name server, enter the ip name-server vrf
Mgmt-intf IPv4-or-IPv6-address
command.
Router(config)# ip name-server vrf Mgmt-intf IPv4-or-IPv6-address
RADIUS or TACACS+ Server
To group the Management VRF as part of a AAA server group, enter the ip vrf forward Mgmt-intf
command when configuring the AAA server group.
To Next Page
Loading...
Need help?
General
