Cisco ASR1002 - ASR 1002 Router Software Configuration Guide

Software Upgrade Process
ISSU Upgrade for Redundant Platforms
6
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
• Using ISSU to Perform a Consolidated Package Upgrade in a Dual Route Processor Configuration,
page 6
• Using ISSU to Upgrade the SubPackages in a Dual Route Processor Configuration, page 12
Using ISSU to Perform a Consolidated Package Upgrade in a Dual Route Processor Configuration
Consolidated packages can only be upgraded using ISSU in dual Route Processor configurations. ISSU
is not supported for consolidated package upgrades in single Route Processor configurations.
If you want the RPs on your Cisco ASR 1000 Series router to be running using a consolidated package
after t
he ISSU upgrade is complete, use the following instructions:
Note This procedure will only work if the current RPs are already running consolidated packages.
SUMMARY STEPS
1. ip tftp source-interface gigabitethernet slot/port
2. copy tftp: URL-to-target-location
3. copy source-file-system:filename standby-destination-filesystem
4. dir URL-to-target-location
dir U
RL-to-target-stby-location
5. issu loadversion rp upgrade-rp-number standby-file-system:filename
6. issu runversion
7. telnet ip-address port
8. issu acceptversion
9. issu commitversion
10. show version, show version active-RP running, show version active-RP provisioned
show platform
show running-configuration
11. hw-module slot RP slot number reload

Cisco ASR1002 - ASR 1002 Router Specifications

General

Form Factor	Rack-mountable
Maximum Throughput	10 Gbps
Operating System	Cisco IOS XE
Product Type	Router
Product Series	ASR 1000
Model	ASR1002
Encryption Throughput	Up to 2.5 Gbps
Memory	4 GB DRAM
Power Supply	AC or DC
Interfaces	4 x SFP
Redundancy	Power supply (optional)
Input Voltage	100-240 VAC
Modular Slots	2 x SPA slots
Rack Unit Height	2U