Configuring MPLS Layer 2 VPNs
Configuring Gigabit EtherChannel for Virtual Private Wire Service
26
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
Note Ethernet-to-EtherChannel over MPLS (Bridge) Interworking mode is also supported under VLAN.
Any-to-EtherChannel over MPLS (Routed) Interworking
You can configure Any-to-EtherChannel over MPLS (Routed) interworking on the Cisco ASR 1000
Series Routers.
Any-to-EtherChannel over MPLS (Routed) interworking supports the following modes:
• ATM-to-EtherChannel
• Ethernet-to-EtherChannel
• PPP-to-EtherChannel
Configure L2VPN interworking on the upstream interfaces of PE routers. For more information about
con
figuring L2VPN interworking on the PE routers, see L2VPN Interworking Modes, page 2.
For information about how to configure ATM on the do
wnstream interfaces of a PE router, see the
Configuring Frame Relay DLCI-to-ATM AAL5SNAP Bridged Interworking, page 6. Meanwhile,
perform the steps described in the EtherChannel-to-EtherChannel over MPLS (Routed) Interworking,
page 21, on the downstream interfaces of the other PE router.
For the Ethernet-to-EtherChannel mode, see the A
ny-to-EtherChannel over MPLS (Bridged)
Interworking, page 24.
For the PPP-to-EtherChannel mode, perfor
m the steps described in the EtherChannel-to-EtherChannel
over MPLS (Routed) Interworking, page 21, on the downstream interfaces of the other PE router.
Meanwhile, perform the following steps on the do
wnstream interfaces of the PE routers.
SUMMARY STEPS
1. enable
2. configure terminal
3. (Optional) ipv6 unicast-routing
4. mpls ip default-route
5. mpls ldp graceful-restart
6. xconnect logging pseudowire status
7. controller t1 slot | subslot | port
8. clock source internal
9. linecode b8zs
10. cablelength long db-loss-value
11. channel-group channel-group-number timeslots range
12. exit
13. pseudowire-class pw-class-name
14. encapsulation mpls
15. interworking ethernet
16. exit
To Next Page
Loading...
Need help?
General
