Configuring Call Home
How to Configure Call Home
14
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
Configuring a Trustpoint Certificate Authority
If you are using the HTTP transport method and specifying an HTTPS destination URL, then you will
also need to configure a trustpoint certificate authority (CA).
For more information about how to configure a trustpoint CA, see the “D
eclare and Authenticate a CA
Trustpoint” section on page 31. That section describes how to configure a CA trustpoint for a secure
Cisco server to use with the Smart Call Home servi
ce, but can be applied to other secure server
configuration as needed by your site using the required certificate for your secure server.
Working With Destination Profiles
This section describes some of the tasks that you can complete with destination profiles:
• Activating and Deactivating a Destination Profile, page 14
• Copying a Destination Profile, page 15
• Renaming a Destination Profile, page 16
• Using the Predefined CiscoTAC-1 Destination Profile, page 17
Activating and Deactivating a Destination Profile
Except for the predefined CiscoTAC-1 profile, all Call Home destination profiles are automatically
activated once you create them. If you do not want to use a profile right way, you can deactivate the
profile. The CiscoTAC-1 profile is inactive by default and must be activated to be used.
To activate or deactivate a destination profile, complete the following steps:
SUMMARY STEPS
1. configure terminal
2. call-home
3. profile name
4. active
5. no active
6. end
Step 9
exit
Example:
Router(cfg-call-home-profile)# exit
Exits call home destination profile configuration mode and
returns to call home configuration mode.
Step 10
end
Example:
Router(cfg-call-home)# end
Returns to privileged EXEC mode.
Command or Action Purpose
To Next Page
Loading...
Need help?
General
