Configuring MPLS Layer 2 VPNs
Configuring Gigabit EtherChannel for Virtual Private Wire Service
28
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
DETAILED STEPS
Command or Action Purpose
Step 1
enable
Example:
Router> enable
Enables the privileged EXEC mode.
Enter your password, if prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters the global configuration mode.
Step 3
ipv6 unicast-routing
Example:
Router# ipv6 unicast-routing
(Optional) Enables the task of forwarding the IPv6
unicast datagrams.
Step 4
mpls ip default-route
Example:
Router(config)# mpls ip default-route
Enables the distribution of labels associated with the
IP default route.
Step 5
mpls ldp graceful-restart
Example:
Router(config)# mpls ldp graceful-restart
Enables MPLS LDP graceful restart.
Step 6
xconnect logging pseudowire status
Example:
Router(config)# xconnect logging pseudowire status
Enables system logging (syslog) reporting of
pseudowire status events.
Step 7
controller t1 slot/subslot/port
Example:
Router(config)# controller T1 0/3/0
Configures a T1 controller and enters the controller
configuration mode.
Step 8
clock source internal
Example:
Router(config-controller)# clock source internal
Configures the clock source of a DS1 link and uses
the internal clock from the interface.
Step 9
linecode b8zs
Example:
Router(config-controller)# linecode b8zs
Specifies Binary 8-Zero Substitution (B8ZS) as the
line code type for the T1 controller.
Step 10
cablelength long db-loss-value
Example:
Router(config-controller)# cablelength long 0db
Decreases the transmit signal by 0 dB. This is the
default value.
To Next Page
Loading...
