Cisco Catalyst 4500 Series System Message Guide

2-83
Catalyst 4500 Series Switch Cisco IOS System Message Guide
OL-13091-01
Chapter 2 Messages and Recovery Procedures
PM Messages
Error Message PM-4-PORT_BOUNCED: Port [char] was bounced by [char].
Explanation
The Port Manager needed to perform a reactivation of a port in the link-down state
during a switchover. A port is only reactivated when the port data structures lack consistency
between the active and standby supervisor engines. The reactivation event returned the active ports
in the link-down state to the link-up state.
Recommended Action This is an informational message only. No action is required.
Error Message PM-4-PORT_CONSISTENT:Port [char] consistency has been restored
Explanation The port manager on the standby supervisor engine discovered that the port state
became consistent again.
Recommended Action This is an informational message only. No action is required.
Error Message PM-4-PORT_INCONSISTENT: Port [char] is inconsistent: IDB state [char]
(set %TE ago)
Explanation The port manager on the standby supervisor engine discovered that the port state was
inconsistent for more that one second. Inconsistent ports are reactivated on switchover (you will see
the PORT_BOUNCED message).
Recommended Action This is an informational message only. No action is required.
Error Message PM-4-PVLAN_TYPE_CFG_ERR: Failed to set VLAN [dec] to a [char] VLAN
Explanation The platform failed to set the private VLAN type.
Recommended Action Enter the show tech-support privileged EXEC command to gather data that
might provide information about the error. If you cannot determine the cause of the error from the
error message or from the show tech-support command display, copy the error message exactly as
it appears on the console or in the system log, contact your technical support representative, and
provide the representative with the gathered information.
Error Message PM-4-TOO_MANY_APP:application ‘[char]’ exceeded registration limit
Explanation
The Port Manager detected an invalid request. [char] in the application.
Recommended Action Reconfigure the host access entry using the correct type.
Error Message PM-4-UNKNOWN_HOST_ACCESS: Invalid Host access value ([dec]) is
received
Explanation
A n invalid host access value was sent to the host access table.
Recommended Action Reconfigure the host access entry using the correct type.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E