Name: Cisco Catalyst 9200 Series
Brand: Cisco
Rating: 5 (1 reviews)

To Next Page

To Previous Page

CHAPTER 8

Configuring the Switch

• Configuring the Switch Using the Web User Interface, on page 99

• Configuring the Switch Using the CLI, on page 99

Configuring the Switch Using the Web User Interface

For instructions on setting up the switch using the WebUI, refer to the required version of the software

configuration guide. In the guide, go to Configuring the Switch Using the Web User Interface.

Configuring the Switch Using the CLI

Accessing the CLI Through the Console Port

You can access the CLI on a configured or unconfigured switch by connecting the RJ-45 console port or USB

console port of the switch to your PC or workstation and accessing the switch through a terminal emulation

program.

If you have stacked your switches, connect to the console port of one of the switches in the stack. You

can initially configure the entire stack from any member switch.

Note

Connecting the RJ45 Console Port

Procedure

Step 1 Connect the RJ45 port to the serial port on the terminal server or your PC using the optional RJ45-to-DB9

adapter cable. Connect the other end of the cable to the switch console port.

Step 2 Start the terminal-emulation program on the PC or the terminal. The program, frequently a PC application

such as Putty or TeraTerm, makes communication between the switch and your PC or terminal possible.

Step 3 Configure the baud rate and character format of the PC or terminal to match the console port default

characteristics:

Cisco Catalyst 9200 Series Switches Hardware Installation Guide

Other manuals for Cisco Catalyst 9200 Series

Questions and Answers:

Need help?

Do you have a question about the Cisco Catalyst 9200 Series and is the answer not in the manual?

General