Cisco Catalyst 9200 Series Hardware Installation Guide

Figure 8: Components delivered in the shipping box
Cable guide8Cisco Catalyst 9200 Series switch
1
(power
supply modules are not displayed)
1
M4.0 x 20mm Phillips pan-head screw9AC power cord2
RJ-45 USB console cable
1
10Four rubber mounting feet3
(Optional) USB console cable
1
11Two 19-inch mounting brackets4
(Optional) StackWise cable
1
(0.5-meter,
1-meter, or 3-meter)
124 number-12 pan-head screw5
Power cord retainer134 number-10 pan-head screws6
--8 number-8 Phillips flat-head screws7
1. Item is orderable.
Planning a Switch Data Stack
Switch Stacking Guidelines
A StackWise adapter must be installed in the stacking port to enable stacking. The StackWise cable connects
to the StackWise adapter in the stacking port. If the switch is not ordered with stacking, the adapters must be
ordered separately and installed.
Before connecting the switches in a stack, observe these stacking guidelines:
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
32
Installing the Switch
Planning a Switch Data Stack

Cisco Catalyst 9200 Series Specifications

General

Category	Switch
Stacking Bandwidth	160 Gbps
Layer	Layer 2 and Layer 3
Operating System	Cisco IOS XE
Operating Temperature	0°C to 45°C (32°F to 113°F)
Series	Cisco Catalyst 9200 Series
Ports	24 or 48 Ethernet ports
Switching Capacity	Up to 176 Gbps
PoE	PoE, PoE+, and UPOE
Stacking	StackWise-160
Memory	4 GB DRAM, 4 GB Flash
Network Management	Cisco DNA Center, WebUI, CLI
Security Features	802.1X, TrustSec, MACsec
Warranty	Limited Lifetime Warranty
Dimensions	1.73 x 17.5 x 11.3 in. (4.4 x 44.5 x 28.8 cm)