Cisco Catalyst 9200 Series Hardware Installation Guide

1. Item is orderable.
Mounting the Switch
The following table explains the different mounting options supported by C9200CX compact switches.
Table 13: Mounting Options
Accessories UsedMounting Method
• Mounting using the Mounting Tray and Screws
• Mounting using the Mounting Tray and Magnet
Wall mount
• Mounting the Switch Using Rack Mount
Brackets
Rack mount
• Mounting Under a Desk or a Shelf
• Mounting using the Mounting Tray and Magnet
Shelf or top/bottom of a desk mount
• Mounting the Switch on a DIN RailDin rail mount
Mounting on a Desk or Shelf Without Mounting Screws
Procedure
Step 1 Locate the adhesive strip with the rubber feet in the accessory kit.
Step 2 Remove the four rubber feet from the adhesive strip, and attach them to the locations indicated at the bottom
of the unit. This prevents the switch from sliding on the desk or shelf.
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
51
Installing a Compact Switch
Mounting the Switch

Cisco Catalyst 9200 Series Specifications

General

Category	Switch
Stacking Bandwidth	160 Gbps
Layer	Layer 2 and Layer 3
Operating System	Cisco IOS XE
Operating Temperature	0°C to 45°C (32°F to 113°F)
Series	Cisco Catalyst 9200 Series
Ports	24 or 48 Ethernet ports
Switching Capacity	Up to 176 Gbps
PoE	PoE, PoE+, and UPOE
Stacking	StackWise-160
Memory	4 GB DRAM, 4 GB Flash
Network Management	Cisco DNA Center, WebUI, CLI
Security Features	802.1X, TrustSec, MACsec
Warranty	Limited Lifetime Warranty
Dimensions	1.73 x 17.5 x 11.3 in. (4.4 x 44.5 x 28.8 cm)