Cisco Catalyst 9200 Series Hardware Installation Guide

Figure 42: Attaching the Power Cord Retainer Strap
Power cord retainer strap2M3x6mm pan-head screw1
Step 2 Slide the retainer clamp around the AC power cord and position it closest to the connector on the adapter.
Depending on the width of the power cord, adjust the size of the retainer clamp, if required.
Note
Figure 43: Sliding the Retainer Clamp Through the Power Cord
Power cord retainer clamp2AC power cord connector1
Step 3 Insert the retainer strap through the latch at the bottom of the clamp and press the tabs on the retainer clamp
towards each other to secure the power cord.
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
70
Installing a Compact Switch
Installing the Power Cord Retainer (Optional)

Cisco Catalyst 9200 Series Specifications

General

Category	Switch
Stacking Bandwidth	160 Gbps
Layer	Layer 2 and Layer 3
Operating System	Cisco IOS XE
Operating Temperature	0°C to 45°C (32°F to 113°F)
Series	Cisco Catalyst 9200 Series
Ports	24 or 48 Ethernet ports
Switching Capacity	Up to 176 Gbps
PoE	PoE, PoE+, and UPOE
Stacking	StackWise-160
Memory	4 GB DRAM, 4 GB Flash
Network Management	Cisco DNA Center, WebUI, CLI
Security Features	802.1X, TrustSec, MACsec
Warranty	Limited Lifetime Warranty
Dimensions	1.73 x 17.5 x 11.3 in. (4.4 x 44.5 x 28.8 cm)