EasyManuals Logo

Cisco Firepower 1100 User Manual

Cisco Firepower 1100
176 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #147 background imageLoading...
Page #147 background image
This command returns you to the FXOS CLI prompt. For information on the commands available in the FXOS
CLI, enter ?.
Example:
> exit
firepower#
Troubleshoot Management Connectivity on a Data Interface
Model Support—FTD
When you use a data interface for FMC management instead of using the dedicated Management interface,
you must be careful about changing the interface and network settings for the FTD in FMC so you do not
disrupt the connection. If you change the management interface type after you add the FTD to the FMC (from
data to Management, or from Management to data), if the interfaces and network settings are not configured
correctly, you can lose management connectivity.
This topic helps you troubleshoot the loss of management connectivity.
View management connection status
In FMC, check the management connection status on the Devices > Device Management > Device >
Management > FMC Access Details > Connection Status page.
At the FTD CLI, enter the sftunnel-status-brief command to view the management connection status.
You can also use sftunnel-status to view more complete information.
See the following sample output for a connection that is down; there is no peer channel "connected to"
information, nor heartbeat information shown:
> sftunnel-status-brief
PEER:10.10.17.202
Registration: Completed.
Connection to peer '10.10.17.202' Attempted at Mon Jun 15 09:21:57 2020 UTC
Last disconnect time : Mon Jun 15 09:19:09 2020 UTC
Last disconnect reason : Both control and event channel connections with peer went down
See the following sample output for a connection that is up, with peer channel and heartbeat information
shown:
> sftunnel-status-brief
PEER:10.10.17.202
Peer channel Channel-A is valid type (CONTROL), using 'eth0', connected to '10.10.17.202'
via '10.10.17.222'
Peer channel Channel-B is valid type (EVENT), using 'eth0', connected to '10.10.17.202'
via '10.10.17.222'
Registration: Completed.
IPv4 Connection to peer '10.10.17.202' Start Time: Wed Jun 10 14:27:12 2020 UTC
Heartbeat Send Time: Mon Jun 15 09:02:08 2020 UTC
Heartbeat Received Time: Mon Jun 15 09:02:16 2020 UTC
Cisco Firepower 1100 Getting Started Guide
145
Firepower Threat Defense Deployment with a Remote FMC
Troubleshoot Management Connectivity on a Data Interface

Table of Contents

Other manuals for Cisco Firepower 1100

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Firepower 1100 and is the answer not in the manual?

Cisco Firepower 1100 Specifications

General IconGeneral
BrandCisco
ModelFirepower 1100
CategoryFirewall
LanguageEnglish

Related product manuals