Cisco Firepower 1100 User Manual

Obtain Licenses for the Firepower Management Center, on page 97: Buy
feature licenses.
Cisco Commerce
Workspace
Obtain Licenses for the Firepower Management Center, on page 97: Generate
a license token for the FMC.
Smart Software
Manager
Obtain Licenses for the Firepower Management Center, on page 97: Register
the FMC with the Smart Licensing server.
Firepower
Management Center
Register the FTD with the FMC, on page 98.Firepower
Management Center
Configure a Basic Security Policy, on page 100.Firepower
Management Center
Review the Network Deployment
The dedicated Management 1/1 interface is a special interface with its own network settings. By default, the
Management 1/1 interface is enabled and configured as a DHCP client. If your network does not include a
DHCP server, you can set the Management interface to use a static IP address during initial setup at the console
port. You can configure other interfaces after you connect the FTD to FMC.
In 6.5 and earlier, the Management interface is configured with an IP address (192.168.45.45).
Note
See the following sample network deployments for ideas on how to place your FTD device in your network.
Separate Management Network
Both the FMC and FTD require internet access from management for licensing and updates.
The following figure shows a possible network deployment for the Firepower 1100 where the FMC and
management computer connect to the management network. The management network has a path to the
internet for licensing and updates.
Cisco Firepower 1100 Getting Started Guide
88
Firepower Threat Defense Deployment with FMC
Review the Network Deployment

Cisco Firepower 1100 Specifications

General

Brand	Cisco
Model	Firepower 1100
Category	Firewall
Language	English