Cisco Firepower 1100 User Manual

CHAPTER 7
ASA Deployment with ASDM
Is This Chapter for You?
This chapter describes how to set up the Firepower 1100 for use with the ASA. This chapter does not cover
the following deployments, for which you should refer to the ASA configuration guide:
• Failover
• CLI configuration
This chapter also walks you through configuring a basic security policy; if you have more advanced
requirements, refer to the configuration guide.
The Firepower 1100 hardware can run either ASA software or FTD software. Switching between ASA and
FTD requires you to reimage the device. See Reimage the Cisco ASA or Firepower Threat Defense Device.
The Firepower 1100 runs an underlying operating system called the Firepower eXtensible Operating System
(FXOS). The Firepower 1100 does not support the FXOS Firepower Chassis Manager; only a limited CLI is
supported for troubleshooting purposes. See the FXOS troubleshooting guide for more information.
PrivacyCollection Statement—The Firepower 1100 does not require or actively collect personally-identifiable
information. However, you can use personally-identifiable information in the configuration, for example for
usernames. In this case, an administrator might be able to see this information when working with the
configuration or when using SNMP.
• About the ASA, on page 154
• End-to-End Procedure, on page 156
• Review the Network Deployment and Default Configuration, on page 157
• Cable the Device, on page 159
• Power on the Device, on page 160
• (Optional) Change the IP Address, on page 161
• Log Into ASDM, on page 162
• Configure Licensing, on page 163
• Configure the ASA, on page 168
• Access the ASA and FXOS CLI, on page 170
• What's Next?, on page 171
Cisco Firepower 1100 Getting Started Guide
153

Cisco Firepower 1100 Specifications

General

Brand	Cisco
Model	Firepower 1100
Category	Firewall
Language	English