EasyManuals Logo

Cisco Firepower 1100 User Manual

Cisco Firepower 1100
176 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #149 background imageLoading...
Page #149 background image
Type : Manager
Host : 10.89.5.35
Registration : Completed
>
Ping the FMC
At the FTD CLI, use the following command to ping the FMC from the data interfaces:
ping fmc_ip
At the FTD CLI, use the following command to ping the FMC from the Management interface, which
should route over the backplane to the data interfaces:
ping system fmc_ip
Capture packets on the FTD internal interface
At the FTD CLI, capture packets on the internal backplane interface (nlp_int_tap) to see if management
packets are being sent:
capture name interface nlp_int_tap trace detail match ip any any
show capturename trace detail
Check the internal interface status, statistics, and packet count
At the FTD CLI, see information about the internal backplane interface, nlp_int_tap:
show interace detail
> show interface detail
[...]
Interface Internal-Data0/1 "nlp_int_tap", is up, line protocol is up
Hardware is en_vtun rev00, BW Unknown Speed-Capability, DLY 1000 usec
(Full-duplex), (1000 Mbps)
Input flow control is unsupported, output flow control is unsupported
MAC address 0000.0100.0001, MTU 1500
IP address 169.254.1.1, subnet mask 255.255.255.248
37 packets input, 2822 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 pause input, 0 resume input
0 L2 decode drops
5 packets output, 370 bytes, 0 underruns
0 pause output, 0 resume output
0 output errors, 0 collisions, 0 interface resets
0 late collisions, 0 deferred
0 input reset drops, 0 output reset drops
input queue (blocks free curr/low): hardware (0/0)
output queue (blocks free curr/low): hardware (0/0)
Traffic Statistics for "nlp_int_tap":
37 packets input, 2304 bytes
5 packets output, 300 bytes
37 packets dropped
1 minute input rate 0 pkts/sec, 0 bytes/sec
1 minute output rate 0 pkts/sec, 0 bytes/sec
1 minute drop rate, 0 pkts/sec
5 minute input rate 0 pkts/sec, 0 bytes/sec
5 minute output rate 0 pkts/sec, 0 bytes/sec
5 minute drop rate, 0 pkts/sec
Control Point Interface States:
Interface number is 14
Cisco Firepower 1100 Getting Started Guide
147
Firepower Threat Defense Deployment with a Remote FMC
Troubleshoot Management Connectivity on a Data Interface

Table of Contents

Other manuals for Cisco Firepower 1100

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Firepower 1100 and is the answer not in the manual?

Cisco Firepower 1100 Specifications

General IconGeneral
BrandCisco
ModelFirepower 1100
CategoryFirewall
LanguageEnglish

Related product manuals