Cisco Firepower 1100 User Manual

Cable the Device
For 6.7 and earlier, the Ethernet 1/2 inside IP address is 192.168.1.1.
For 6.5 and earlier, the Management 1/1 default IP address is 192.168.45.45.
Note
Manage the Firepower 1100 on either Management 1/1 or Ethernet 1/2. The default configuration also
configures Ethernet1/1 as outside.
Procedure
Step 1 Connect your management computer to either of the following interfaces:
• Ethernet 1/2—Connect your management computer directly to Ethernet 1/2 for initial configuration, or
connect Ethernet 1/2 to your inside network. Ethernet 1/2 has a default IP address (192.168.95.1) and
also runs a DHCP server to provide IP addresses to clients (including the management computer), so
make sure these settings do not conflict with any existing inside network settings (see Default
Configuration, on page 64).
• Management 1/1 (labeled MGMT)—Connect Management 1/1 to your management network, and make
sure your management computer is on—or has access to—the management network. Management 1/1
obtains an IP address from a DHCP server on your management network; if you use this interface, you
must determine the IP address assigned to the FTD so that you can connect to the IP address from your
management computer.
If you need to change the Management 1/1 IP address from the default to configure a static IP address,
you must also cable your management computer to the console port. See (Optional) Change Management
Network Settings at the CLI, on page 67.
You can later configure FDM management access from other interfaces; see the FDM configuration guide.
Step 2 Connect the outside network to the Ethernet1/1 interface (labeled WAN).
Cisco Firepower 1100 Getting Started Guide
66
Firepower Threat Defense Deployment with FDM
Cable the Device

Cisco Firepower 1100 Specifications

General

Brand	Cisco
Model	Firepower 1100
Category	Firewall
Language	English