EasyManuals Logo

Cisco Firepower 1100 User Manual

Cisco Firepower 1100
176 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #71 background imageLoading...
Page #71 background image
Enter the IPv4 default gateway for the management interface—If you set a manual IP address, enter
either data-interfaces or the IP address of the gateway router. The data-interfaces setting sends outbound
management traffic over the backplane to exit a data interface. This setting is useful if you do not have
a separate Management network that can access the internet. Traffic originating on the Management
interface includes license registration and database updates that require internet access. If you use
data-interfaces, you can still use FDM (or SSH) on the Management interface if you are
directly-connected to the Management network, but for remote management for specific networks or
hosts, you should add a static route using the configure network static-routes command. Note that
FDM management on data interfaces is not affected by this setting. If you use DHCP, the system uses
the gateway provided by DHCP and uses the data-interfaces as a fallback method if DHCP doesn't
provide a gateway.
If your networking information has changed, you will need to reconnect—If you are connected with
SSH to the default IP address but you change the IP address at initial setup, you will be disconnected.
Reconnect with the new IP address and password. Console connections are not affected.
Manage the device locally?—Enter yes to use CDO or FDM. A no answer means you intend to use the
FMC to manage the device.
Example:
You must accept the EULA to continue.
Press <ENTER> to display the EULA:
End User License Agreement
[...]
Please enter 'YES' or press <ENTER> to AGREE to the EULA:
System initialization in progress. Please stand by.
You must configure the network to continue.
You must configure at least one of IPv4 or IPv6.
Do you want to configure IPv4? (y/n) [y]:
Do you want to configure IPv6? (y/n) [n]:
Configure IPv4 via DHCP or manually? (dhcp/manual) [manual]:
Enter an IPv4 address for the management interface [192.168.45.45]: 10.10.10.15
Enter an IPv4 netmask for the management interface [255.255.255.0]: 255.255.255.192
Enter the IPv4 default gateway for the management interface [data-interfaces]: 10.10.10.1
Enter a fully qualified hostname for this system [firepower]: ftd-1.cisco.com
Enter a comma-separated list of DNS servers or 'none' [208.67.222.222,208.67.220.220]:
Enter a comma-separated list of search domains or 'none' []:
If your networking information has changed, you will need to reconnect.
For HTTP Proxy configuration, run 'configure network http-proxy'
Manage the device locally? (yes/no) [yes]: yes
>
Step 4 Log into FDM on the new Management IP address.
Log Into FDM
Log into FDM to configure your FTD.
Cisco Firepower 1100 Getting Started Guide
69
Firepower Threat Defense Deployment with FDM
Log Into FDM

Table of Contents

Other manuals for Cisco Firepower 1100

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Firepower 1100 and is the answer not in the manual?

Cisco Firepower 1100 Specifications

General IconGeneral
BrandCisco
ModelFirepower 1100
CategoryFirewall
LanguageEnglish

Related product manuals