Cisco Firepower 1100

Figure 10: Suggested Network Deployment On-Premises SDC
For 6.7 and earlier, the Ethernet 1/2 inside IP address is 192.168.1.1.
For 6.5 and earlier, the Management 1/1 default IP address is 192.168.45.45.
Note
Default Configuration
The configuration for the f after initial setup includes the following:
• inside—Ethernet 1/2, IP address (7.0 and later) 192.168.95.1; (pre-7.0) 192.168.1.1.
• outside—Ethernet 1/1, IP address from IPv4 DHCP and IPv6 autoconfiguration
• inside→outside traffic flow
• management—Management 1/1 (management)
• (6.6 and later) IP address from DHCP
• (6.5 and earlier) IP address 192.168.45.45
Cisco Firepower 1100 Getting Started Guide
30
Firepower Threat Defense Deployment with CDO
Default Configuration