Cisco Firepower 1100 User Manual

About the ASA
The ASA provides advanced stateful firewall and VPN concentrator functionality in one device.
You can manage the ASA using one of the following managers:
• ASDM (Covered in this guide)—A single device manager included on the device.
• CLI
• Cisco Security Manager—A multi-device manager on a separate server.
You can also access the FXOS CLI for troubleshooting purposes.
Unsupported Features
The following ASA features are not supported on the Firepower 1100:
• Redundant interfaces
• Clustering
• ASA REST API
• ASA FirePOWER module
• Botnet Traffic Filter
• The following inspections:
• SCTP inspection maps (SCTP stateful inspection using ACLs is supported)
• Diameter
• GTP/GPRS
Migrating an ASA 5500-X Configuration
You can copy and paste an ASA 5500-X configuration into the Firepower 1100. However, you will need to
modify your configuration. Also note some behavioral differences between the platforms.
1. To copy the configuration, enter the more system:running-config command on the ASA 5500-X.
2. Edit the configuration as necessary (see below).
3. Connect to the console port of the Firepower 1100, and enter global configuration mode:
ciscoasa> enable
Password:
The enable password is not set. Please set it now.
Enter Password: ******
Repeat Password: ******
ciscoasa# configure terminal
ciscoasa(config)#
Cisco Firepower 1100 Getting Started Guide
154
ASA Deployment with ASDM
About the ASA

Cisco Firepower 1100 Specifications

General

Brand	Cisco
Model	Firepower 1100
Category	Firewall
Language	English