Cisco IE-3000-8TC Message Guide

2-69
Cisco IE 3000 Switch System Message Guide
OL-13020-01
Chapter 2 Message and Recovery Procedures
SW_VLAN Messages
Error Message SW_VLAN-4-VLAN_CREATE_FAIL: Failed to create VLANs [chars]: [chars].
Explanation The specified VLANs could not be created. The port manager might not have completed
the VLAN creation requests because the VLANs already exist as internal VLANs. The first [chars]
is the VLAN ID, and the second [chars] describes the error.
Recommended Action Check the internal VLAN usage by using show vlan internal usage privileged
EXEC command, reconfigure the feature that is using the internal VLANs, and try to create the
VLANs again. If this message appears again, copy the message exactly as it appears on the console
or in the system log. Research and attempt to resolve the error by using the Output Interpreter. Enter
the show tech-support user EXEC command to gather data that might help identify the nature of
the error. Use the Bug Toolkit to look for similar reported problems. If you still require assistance,
open a case with the TAC, or contact your Cisco technical support representative, and provide the
representative with the gathered information. For more information about these online tools and about
contacting Cisco, see the
“Error Message Traceback Reports” section on page 1-4.
Error Message SW_VLAN-4-VTP_INTERNAL_ERROR: VLAN manager received an internal error
[dec] from vtp function [chars] [chars].
Explanation The VLAN manager received an unexpected error code from the VTP configuration
software. [dec] is the error code, the first [chars] is the VTP function, and the second [chars] is the
error-code description.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Enter the show
tech-support user EXEC command to gather data that might help identify the nature of the error.
Use the Bug Toolkit to look for similar reported problems. If you still require assistance, open a case
with the TAC, or contact your Cisco technical support representative, and provide the representative
with the gathered information. For more information about these online tools and about contacting
Cisco, see the
“Error Message Traceback Reports” section on page 1-4.
Error Message SW_VLAN-4-VTP_INVALID_DATABASE_DATA: VLAN manager received bad data of
type [chars] value [dec] from vtp database function [chars].
Explanation The VLAN manager received invalid data from a VTP configuration database routine.
The first [chars] is the data type, [dec] is the inappropriate value that was received, and the second
[chars] is the VTP database function.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Enter the show
tech-support user EXEC command to gather data that might help identify the nature of the error.
Use the Bug Toolkit to look for similar reported problems. If you still require assistance, open a case
with the TAC, or contact your Cisco technical support representative, and provide the representative
with the gathered information. For more information about these online tools and about contacting
Cisco, see the
“Error Message Traceback Reports” section on page 1-4.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes