Send comments to mdsfeedback-doc@cisco.com.
5-26
Cisco MDS 9000 Family Troubleshooting Guide
OL-5183-02, Cisco MDS SAN-OS Release 1.3
Chapter 5 Troubleshooting IP Storage Issues
Troubleshooting FCIP Connections
FCIP Special Frame Tunnel Creation and Monitoring
Previous FCIP tunnel configuration must be completed before adding FCIP Special Frame configuration.
This section describes how to correctly configure and show an FCIP tunnel with a Special Frame.
MDS2# show wwn switch
Switch WWN is 20:00:00:0b:5f:d5:9f:c0
(You’ll need the WWN of each MDS 9000 switch end point.)
MDS1(config)# int fcip 21
MDS1(config-if)# special-frame peer-wwn 20:00:00:0b:5f:d5:9f:c0 profile-id 1
(This enables the Special Frame that is used in the creation of the FCIP tunnel.)
MDS1# show wwn switch
Switch WWN is 20:00:00:05:30:00:59:de
MDS2(config)# int fcip 21
MDS2(config-if)# special-frame peer-wwn 20:00:00:05:30:00:59:de profile-id 1
module-2#
Jan 14 15:25:38 port1: 857314:FCIP21: SUP-> Set Port mode 1
Jan 14 15:25:38 port1: 857315:FCIP21: SUP-> Port VSAN (1) already set to same value
Jan 14 15:25:38 port1: 857316:FCIP21: SUP-> Trunk mode (1) already set to same value
Jan 14 15:25:38 port1: 857317:FCIP21: SUP-> Enable tunnel ADMIN UP
Jan 14 15:25:38 port1: 857318:FCIP21: Try to Bring UP the Tunnel
Jan 14 15:25:38 port1: 857319:FCIP21: Start TCP listener with peer: 10.10.10.2:3225
Jan 14 15:25:38 port1: 857320:FCIP: Create a new listener object for 10.10.11.2:3225
Jan 14 15:25:38 port1: 857321:FCIP: Create FCIP Listener with local info: 10.10.11.2:3225
Jan 14 15:25:38 port1: 857322:FCIP21: Create a DE 0xd802cd00 for this tunnel
Jan 14 15:25:38 port1: 857323:FCIP21: Bind the DE 0xd802cd00 [1] to tunnel LEP 0x80111570
Jan 14 15:25:38 port1: 857324:FCIP21: Start the active connection [1] to 10.10.10.2:3225
Jan 14 15:25:38 port1: 857325:FCIP21: Create a DE 0xd802db40 for this tunnel
Jan 14 15:25:38 port1: 857326:FCIP21: Bind the DE 0xd802db40 [2] to tunnel LEP 0x80111570
Jan 14 15:25:38 port1: 857327:FCIP21: Start the active connection [2] to 10.10.10.2:3225
Jan 14 15:25:38 port1: 857328:FCIP21: Active Connect creation SUCCEEDED [1]
Jan 14 15:25:38 port1: 857329:FCIP21: Bind DE 1 to TCP-hdl 0xd8072c00
Jan 14 15:25:38 port1: 857330:FCIP21: Setup for Special Frame handling: I'm Originator
(This begins the Special Frame setup of the Originator.)
Jan 14 15:25:38 port1: 857331:FCIP21: Send the SF as Originator & wait for response
(The Special Frame is sent.)
Jan 14 15:25:38 port1: 857332:FCIP21: Setup timer to wait for SF
Jan 14 15:25:38 port1: 857333:FCIP21: Active Connect creation SUCCEEDED [2]
(The Special Frame is correctly configured with the WWN of the remote MDS 9000 switch.)
Jan 14 15:25:38 port1: 857334:FCIP21: Bind DE 2 to TCP-hdl 0xd8072000
Jan 14 15:25:38 port1: 857335:FCIP21: Setup for Special Frame handling: I'm Originator
Jan 14 15:25:38 port1: 857336:FCIP21: Send the SF as Originator & wait for response
Jan 14 15:25:38 port1: 857337:FCIP21: Setup timer to wait for SF
Jan 14 15:25:38 port1: 857338:FCIP21: processing SF frame, I'm Originator
Jan 14 15:25:38 port1: 857339:FCIP21: Bind DE 1 to eport 0x80110550
Jan 14 15:25:38 port1: 857340:FCIP21: bind de 1 in eport 0x80110550, hash = 1 num-conn: 2
Jan 14 15:25:38 port1: 857341:FCIP21: processing SF frame, I'm Originator
Jan 14 15:25:38 port1: 857342:FCIP21: Bind DE 2 to eport 0x80110550
Jan 14 15:25:38 port1: 857343:FCIP21: bind de 2 in eport 0x80110550, hash = 2 num-conn: 2
Jan 14 15:25:38 port1: 857344:FCIP21: Send LINK UP to SUP
Jan 14 15:25:39 port1: 857345:FCIP21: SUP-> Set trunk mode: 2
Jan 14 15:25:39 port1: 857346:FCIP21: Change the operational mode to TRUNK
Jan 14 15:25:39 port1: 857347:FCIP21: *** Received non-eisl frame in TE mode 64 64
MDS2# show int fcip 21
fcip21 is trunking
To Next Page
Loading...
Need help?
General
