Cisco MDS 9000 Series Troubleshooting Guide

Send comments to mdsfeedback-doc@cisco.com.
3-24
Cisco MDS 9000 Family Troubleshooting Guide
OL-5183-02, Cisco MDS SAN-OS Release 1.3
Chapter 3 Troubleshooting Switch Level Issues and Interswitch Connectivity
Troubleshooting Fx Port Connectivity
0 runts, 0 jabber, 0 too long, 0 too short
0 input errors, 0 CRC, 3 invalid transmission words
0 address id, 0 delimiter
0 EOF abort, 0 fragmented, 0 unknown class
514 frames output, 7509 bytes, 16777216 discards
Received 30 OLS, 21 LRR, 18 NOS, 53 loop inits
Transmitted 68 OLS, 25 LRR, 28 NOS, 32 loop inits
Using the GUI to Troubleshoot VSAN Membership Problems
Checking the VSAN membership can also be done using the Device Manager.
Another tool that may be used to verify different categories of problems (VSANs, zoning, fcdomain,
admin issues, or other switch-specific or fabric-specific issues) is the Fabric Analysis tool provided by
Fabric Manager.
The possible configuration consistency check tool is also provided by this application. Refer to the Cisco
MDS 9000 Fabric Manager User Guide for further information about this tool.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available