Figure 46: Removing the EMI Panel
Remove the EMI panel from the chassis.2Unscrew four captive screws until they are each clear of the chassis.1
b) On each side of the EMI panel, align a side frame piece so that its two screw holes align to two screw holes on one
side of the EMI panel. Screw in a screw in each of these two screw holes so that the side frame assembly is attached
to the EMI panel. Repeat this step for the other side of the EMI panel. See Figure 47: Attaching the Side Frame
Assemblies to the EMI Panel, on page 91.
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
90
Installing a Cisco Nexus 7010 Chassis
Installing the Front Doors and Frame Assembly
To Next Page
Loading...
