Figure 47: Attaching the Side Frame Assemblies to the EMI Panel
Use two 6-32 x 1/2-inch flat-head screws to attach the right side frame to the right side of the
EMI panel. Tighten the screws to 8 in-lb (0.9 N·m).
3Right side
frame.
1
Use two 6-32 x 1/2-inch flat-head screws to attach the left side frame to the left side of the
EMI panel. Tighten the screws to 8 in-lb (0.9 N·m).
4Left side frame.2
c) Realign the EMI panel to the air intake area on the chassis, screw its four captive screws to the chassis, and tighten
the captive screws to 8 in-lb (0.9 N·m).
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
91
Installing a Cisco Nexus 7010 Chassis
Installing the Front Doors and Frame Assembly
To Next Page
Loading...
