• DWDM-X2-xx.xx
• X2-10GB-CX4
• X2-10GB-ER
• X2-10GB-LR
• X2-10GB-LRM
• X2-10GB-LX4
• X2-10GB-SR
• X2-10GB-ZR
Additionally, you can use the following SFP+ transceivers with the OneX Converter Module (part number
CVR-X2-SFP10G) that adapts SFP+ transceivers to X2 ports:
• SFP-10G-SR
• SFP-H10GB-CUxM
For information on the SFP+ 10GB transceivers, see the 10-Gigabit SFP+ Transceivers and Fabric Extender
Transceivers, on page 213.
Figure 148: 10-Gigabit X2 Transceiver (Latching Sleeve Not Extended), on page 219 identifies the major
features of the X2 transceivers, and Figure 149: X2 Transceiver with Latching Sleeve Extended, on page 220
shows the transceiver with its latching sleeve extended (you pull the sleeve out to remove the transceiver from
the I/O module).
Figure 148: 10-Gigabit X2 Transceiver (Latching Sleeve Not Extended)
Transceiver heat sink5Transmit optical bore1
Module connector6Receive optical bore2
Latch (extended when sleeve is retracted)7Latching sleeve (retracted)3
EMI gasket4
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
219
Transceivers and Module Connectors
10-Gigabit X2 Transceivers
To Next Page
Loading...
