Handles used to reposition the chassis (do not
lift the chassis with these handles—use a
mechanical lift)
8Supervisor modules (1 or 2 modules in slots 9
and 10). These modules are of only one of the
following types (if installing two supervisor
modules, both modules must be the same type
with the same amount of memory):
• Supervisor 1 (N7K-SUP1)
• Supervisor 2 (N7K-SUP2)
• Supervisor 2 Enhanced (N7K-SUP2E)
4
Figure 9: Cable Management System for the Cisco Nexus 7018 Chassis
Upper cable management assemblies3System status LEDs (these LEDs show the
system status displayed by the chassis LEDs)
1
Lower cable management assemblies4Top hood2
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
17
Overview
Cisco Nexus 7018 System
To Next Page
Loading...
