same level as the top of the chassis (see Figure 17: Installing the Cable Management Frames on a Cisco
Nexus 7004 Chassis, on page 35).
2. Fasten the frame to the chassis with three M3 x 10 mm screws (see Callout 2 in Figure 17: Installing the
Cable Management Frames on a Cisco Nexus 7004 Chassis, on page 35). Tighten the screws to 5 to 7
in-lb (0.56 to 0.79 N.m).
3. Repeat Steps 1 and 2 to install the other cable management frame to the chassis.
DETAILED STEPS
Step 1 Align the guide pin on one of the two cable management frames to a guide-pin hole of the same size on the front-mounting
bracket that is already attached to the chassis. The top of the frame should be at the same level as the top of the chassis
(see Figure 17: Installing the Cable Management Frames on a Cisco Nexus 7004 Chassis, on page 35).
Figure 17: Installing the Cable Management Frames on a Cisco Nexus 7004 Chassis
Three M3 x 10 mm screws used to fasten the frame to the
chassis (total of six screws for two frames).
2Guide pins on the cable management frame aligned to
two holes in the front-mount bracket.
1
Step 2 Fasten the frame to the chassis with three M3 x 10 mm screws (see Callout 2 in Figure 17: Installing the Cable Management
Frames on a Cisco Nexus 7004 Chassis, on page 35). Tighten the screws to 5 to 7 in-lb (0.56 to 0.79 N.m).
Step 3 Repeat Steps 1 and 2 to install the other cable management frame to the chassis.
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
35
Installing a Cisco Nexus 7004 Chassis
Installing the Cable Management Frames
To Next Page
Loading...
