Figure 27: Attaching the Left Door Stop
Fasten the left door stopper to the frame with two M3 x 10
mm screws.
2Align the left door stopper to the cable management
frame.
1
Step 2 Place two bushings on the vertical post located half way up the right cable management frame (see Figure 28: Placing
Two Bushings on a Cable Management Frame Hinge Post, on page 62). You must open each bushing to fit it around
the post.
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
61
Installing a Cisco Nexus 7009 Chassis
Installing the Front Door and Air Intake Frame
To Next Page
Loading...
