VPN
Setting Up a Gateway to Gateway (Site to Site) VPN
Cisco Small Business RV0xx Series Routers Administration Guide 131
9
NOTE Before navigating away from this page, click Save to save your settings, or click
Cancel to undo them. Any unsaved changes are abandoned.
Add a New Tunnel
• Tunnel No: The ID number, which is automatically generated
• Tunnel Name: Enter a name for this VPN tunnel, such as Los Angeles Office,
Chicago Branch, or New York Division. This description is for your reference.
It does not have to match the name used at the other end of the tunnel.
• Interface: Select the WAN port to use for this tunnel.
• Enable: Check this box to enable the VPN tunnel, or uncheck it to disable
the tunnel. By default, the tunnel is enabled.
Local Group Setup and Remote Group Setup
Enter the settings described below. The Local settings are for this router, and the
Remote settings are for the router on the other end of the tunnel. Mirror these
settings when configuring the VPN tunnel on the other router.
• Local/Remote Security Gateway Type: Specify the method for identifying
the router to establish the VPN tunnel. The Local Security Gateway is on this
router; the Remote Security Gateway is on the other router. At least one of
the routers must have either a static IP address or a dynamic DNS hostname
to make a connection.
To Next Page
Loading...
Need help?
General
