Cisco RV082 - Small Business VPN Router User Manual

D
Cisco Small Business RV0xx Series Routers Administration Guide 170
Configuring a Gateway-to-Gateway VPN
Tunnel Between RV0xx Series Routers
This appendix explains how to set up a VPN between two RV0xx Series routers.
You can then repeat the procedures to add tunnels to your other sites. A Cisco
RV0xx Series router supports up to 100 VPN tunnels.
NOTE Even if you have an RV0xx Series router on one end of the tunnel, and a different
model on the other end, you can use this information to set up your RV0xx Series
router. Note the shared settings that you need to configure on your other router. Both
devices must use a common key or certificate and must have the same security
policies set up.
Refer to these topics:
Overview, page 1
Topology Options, page 170
Other Design Considerations, page 173
Configuring a VPN Tunnel on a Cisco RV0xx Series Router, page 175
Topology Options
Before you configure the VPN settings on your routers, consider the topology
options. A VPN topology specifies the peers and the networks that are part of the
VPN and how they connect to one another. Depending on the number of sites and
the nature of traffic, you can choose a hub-and-spoke topology or a mesh
topology.

Cisco RV082 - Small Business VPN Router Specifications

General

VPN Tunnels	50
DHCP Server	Yes
Authentication	MD5, SHA1
Power Supply	12V DC, 1A
Humidity	10% to 85% non-condensing
LAN Ports	8 x 10/100 Mbps RJ-45
VPN Protocols	IPSec, PPTP, L2TP
Firewall	SPI
Encryption	DES, 3DES, AES
Memory	8 MB Flash, 32 MB DRAM
Operating Temperature	0 to 40°C
Storage Temperature	-4 to 158°F (-20 to 70°C)
Weight	0.69 kg