Name: Cisco RV082 - Small Business VPN Router
Brand: Cisco
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Setup

Setting Up the Network

Cisco Small Business RV0xx Series Routers Administration Guide 32

• To modify the WAN settings: If you have any unsaved changes on the

Network page, click Save to save your settings before continuing. For the

interface that you want to modify, click the Edit icon to open the Edit WAN

Connection page. For more information, see Editing a WAN Connection,

page 34.

DMZ Setting

On Cisco RV042, RV042G, and RV082, you can configure the Internet/DMZ port

for use as a DMZ (De-Militarized Zone or De-Marcation Zone). Cisco RV016 has a

dedicated DMZ port. A DMZ allows Internet traffic to access specified hosts on

your network, such as FTP servers and web servers. The rest of your network

resources are kept private.

This feature requires that you have a publicly routable IP address for each host on

the DMZ. You can contact your ISP about getting an additional IP address for this

purpose.

NOTE

• Using the DMZ is preferred and is, if practical, a strongly recommended

alternative to using public LAN servers or putting these servers on WAN

ports where they are not protected and not accessible by users on the LAN.

• Each of the servers on the DMZ will need a unique, public Internet IP

address. Your ISP should be able to provide these addresses, as well as

information on setting up public Internet servers. If you plan to use the DMZ

setting, contact your ISP for the static IP information. If your ISP provides

only one static or several dynamic IP addresses, consider using the DMZ

host feature. See Setting Up a DMZ Host, page 43.

Perform the following actions, as needed.

• To configure the DMZ with IPv6 addressing: Click the IPv6 tab. Then

proceed with the other tasks in this section.

Note: The IPv6 tab is available only if Dual-Stack IP is enabled in the IP

Mode section. If you change the IP Mode setting, you must save the settings

before you continue.

• To enable DMZ on the DMZ/Internet port (Cisco RV042, RV042G, and

RV082 only): Check the Enable DMZ box to enable this feature. Then edit

the DMZ settings, as described below. If you want to use the port as a WAN

port instead, uncheck the box, and be sure to configure the WAN settings on

the Dual WAN page. (See Setting Up Dual WAN and Multi-WAN

Connections, page 73.)

Questions and Answers:

Need help?

Do you have a question about the Cisco RV082 - Small Business VPN Router and is the answer not in the manual?

Cisco RV082 - Small Business VPN Router Specifications

General