F
Cisco Small Business RV0xx Series Routers Administration Guide 186
Bandwidth Management
This scenario explains how to ensure Quality of Service (QoS) on Vonage Voice
over Internet Protocol (VoIP) phone service. This example uses Vonage; however,
similar instructions will apply to other VoIP services. Refer to these topics:
• Creation of New Services, page 186
• Creation of New Bandwidth Management Rules, page 187
Creation of New Services
Create two new services, Vonage VoIP and Vonage 2.
STEP 1 Visit Vonage’s website at http://www.vonage.com. Find out the ports used for
Vonage VoIP service.
STEP 2 Access the router’s configuration utility.
STEP 3 Click the System Management tab.
STEP 4 On the
Bandwidth Management
page, click Service Management.
STEP 5 On the
Service Management
page, enter a name, such as Vonage VoIP, in the
Service Name
field.
STEP 6 From the
Protocol
drop-down menu, select the protocol the VoIP service uses. For
example, some VoIP devices use UDP.
STEP 7 Enter its SIP port range in the
Port Range
fields. For example, you can set the Port
Range to 5060 to 5070 to make sure that all active ports are covered.
STEP 8 Click Add to List.
STEP 9 Add a second service. Enter a name, such as Vonage 2, in the
Service Name
field.
STEP 10 From the
Protocol
drop-down menu, select UDP.
To Next Page
Loading...
Need help?
General
