DHCP
Setting Up the DHCP Server or DHCP Relay
Cisco Small Business RV0xx Series Routers Administration Guide 64
4
To open this page: Click DHCP > DHCP Setup in the navigation tree.
NOTE Before navigating away from this page, click Save to save your settings, or click
Cancel to undo them. Any unsaved changes are abandoned.
Enabling DHCP Server and DHCP Relay
Click the IPv4 tab or the IPv6 tab.
Note: The IPv6 tab is available only if you enabled Dual-Stack IP on the Network >
Setup page.
Enter the following settings:
• Enable DHCP server: Check the box to allow the router to dynamically
assign IP addresses to up to 50 connected devices. Uncheck the box if you
have another DHCP server on the network or you want to configure static IP
addresses for your network devices. If you enable this feature, enter the
settings in the Dynamic IP section of the page, as described below. Other
sections of this page are optional.
• DHCP Relay (IPv4 only): If you have another DHCP server, enable DHCP
Relay to allow this router to communicate the clients’ DHCP requests to the
DHCP server. The DHCP Relay mechanism allows the DHCP clients and the
DHCP server to be located on different networks. The DHCP clients will
send DHCP discover broadcast packets to get IP addresses from the DHCP
server. This router will act as DHCP Relay agent and send DHCP unicasts to
DHCP server.
Required: Enter the DHCP Server IP Address. Other sections of this page
are optional.
To Next Page
Loading...
Need help?
General
