Firewall
Access Rules
Cisco RV320/RV325 Administration Guide 77
7
Adding an Access Rule to the IPv4 Access Rule Table
To add (or edit) an IPv4 access rule:
STEP 1 Click the IPv4 tab.
STEP 2 Click Add (or select the row and click Edit).
STEP 3 Select the Action, Allow or Deny, for this rule from the drop-down menu.
STEP 4 Select a Service from the drop-down menu.
STEP 5 Select Log packets matching this rule or No Log.
STEP 6 Select the Source Interface from the drop-down menu.
STEP 7 Select the Source IP address from the drop-down menu. If you selected Single,
enter the source IP address. If you selected Range, enter the range of source IP
addresses.
STEP 8 Select the Destination IP address from the drop-down menu. If you selected
Single, enter the destination IP address. If you selected Range, enter the range of
destination IP addresses.
STEP 9 Configure the Scheduling for this access rule by selecting the time. Select
Always for the access rule to be in effect 24 hours a day. Select Interval to set a
time, and enter the hours and minutes that the access rule is effective in the From
and To fields. For example, 07:00 to 20:00. The access rule does not allow
setting two time intervals.
STEP 10 Select the Effective On days of the week.
STEP 11 Click Save.
Adding an Access Rule to the IPv6 Access Rule Table
To add (or edit) an IPv6 access rule:
STEP 1 Click the IPv6 tab.
STEP 2 Click Add (or select the row and click Edit).
STEP 3 Select the Action, Allow or Deny, for this rule from the drop-down menu.
STEP 4 Select the Service from the drop-down menu.
STEP 5 Select the Log from the drop-down menu.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
