Setup
Setup Network
28 Cisco RV320/RV325 Administration Guide
3
USB1 or USB2 Port Settings
USB port configuration manages the connection between this device and the USB
dongle. It also manages WAN port failover (redundancy). Some USB dongles
configure their credentials automatically. Others, such as the
Verizon UML290VW 4G dongle, require manual configuration. Refer to the
manufacturer's documentation for the dongle for more information.
3G/4G Connection
To establish a 3G or 4G connection, enter the following:
• Pin Code and Confirm Pin Code—PIN code associated with your SIM card.
This field is only displayed for GSM SIM cards.
• Access Point Name—Internet network that the mobile device is
connecting to. Enter the access point name provided by your mobile
network service provider. If you do not know the name of the access point,
contact your service provider.
• Dial Number—Number provided by your mobile network service provider
for the Internet connection.
• Username and Password—User name and password provided by your
mobile network service provider.
• Enable DNS—Check the box to enable DNS.
• DNS Server (Required) and DNS Server (Optional)—IP addresses of the
DNS servers. Optionally, you can enter a second DNS server. The first
available DNS server is used.
• MTU—Maximum transmission unit (MTU) size. Select Auto to set the size
automatically. Otherwise, to set the MTU size manually, select Manual and
enter the MTU size. (The size in bytes of the largest protocol data unit that
the layer can pass.)
To Next Page
Loading...
