Administration: General Information
Using Traceroute
Cisco 220 Series Smart Switches Administration Guide Release 1.1.0.x 67
5
• Host Definition—Select whether to specify the host by its IP address or
name.
• Host IP Address/Name—Enter the IP address or hostname of the host.
• TTL—Select User Defined to enter the maximum number of hops that
Traceroute permits. This is used to prevent a case where the sent frame gets
into an endless loop. The Traceroute command terminates when the
destination is reached or when this value is reached. To use the default value
(30), select Use Default.
STEP 3 Click Apply.
To Next Page
Loading...
